Montarbo T18A Manuel D'instructions page 11

Control and connection panel
4 3
1
IN: balanced input, fitted with a Neutrik Combo
which accepts both 3 pin XLR and jack plugs.
☛ See 'connectors' and 'connections' at pages 37 and 38,
and 'applications' at pages 39 and 40.
2
OUT: balanced output, (in parallel with the input), using a 3 pin
XLR connector. It allows for easy parallel connection of other
T18A / T15A / T12A or active systems.
☛ See 'connectors' and 'connections' at pages 37 and 38,
and 'applications at pages 39 and 40.
3 MASTER LEVEL: it is the master volume control.
Adjusts the input levels of the 2 built-in power amplifiers to
adapt them to the output level of the mixer. It also allows to
adjust the speaker volume when this system is used in parallel
with others.
Typical operating setting is at maximum position.
The trademark Neutrik Combo ® is property of Neutrik
3-way, bi-amplified, active loudspeaker systems
2
1
4
® connector H.F. - M.F. LEVEL: Mid-high frequencies level.
Note: if you are using a Montarbo mixer (or any mixer
having an output level of 0dB), for optimum performance
it is advisable to set both the MASTER LEVEL and the
H.F.-M.F. LEVEL controls fully clockwise (at their
maximum settings).
5
POWER / 0 - I: Mains power on/off switch.
6
Mains power cord socket (with built-in fuse). Use only the
factory supplied mains cable or a suitable cable with a ground
connection and marked with the safety approvals valid in the
country of use.
When installing make sure that it is easy to get to this
connector and to the mains plug.
T18A / T15A / T12A
ENGLISH
11