Cleaning And Disinfection; Lamp Replacement; Warranty - Sunoptic Technologies Pro300 Manuel D'utilisation

8. CLEANING and DISINFECTION

CAUTION: Disconnect power cord before cleaning and while the device is drying.
Disinfecting agents should be commercially available cleansers commonly used for disinfecting
electronic equipment in hospitals. Such cleansers include ethyl or isopropyl alcohols or disinfecting
sprays containing ammonium compounds or hydrogen peroxide.
WARNING: Do not use caustic or acidic cleansers such as "Clorox" hypochlorite bleach, ammonia,
muriatic acid, or similar products. Do not use acetone, methyl ethyl ketone, chlorinated hydrocarbon
solvents, or cleaners containing any of these restricted compounds.
Apply cleaning agents by light spray or dampened cloth.
WARNING: Do not pour liquids over device or allow them to enter seams or openings.
9. MAINTENANCE, SERVICING & REPAIR, WARRANTY
Defective items or equipment shall be serviced and repaired exclusively by persons authorized by the
manufacturer, and all repair work shall include original manufacturer parts.

9.1 Lamp Replacement

WARNING: Xenon ceramic lamps have high internal pressure when cold and at operating
temperatures. As a result, these lamps may rupture causing discharge or hot fragments of glass
or metal to be present: HANDLE WITH CARE.
WARNING: Only handle lamps with plastic protective covers in place. DO NOT handle lamps
without protective cover unless safety glasses, face masks (with neck and chest protectors), and
gauntlets are worn.
CAUTION: Always disconnect power cord from device when changing a lamp.
CAUTION: DO NOT touch the patient and the lamp simultaneously.
CAUTION: Lamp may be very hot. DO NOT touch lamp heat sink when removing lamp.
WARNING: To reduce risk of electric shock, DO NOT touch lamp power connectors located inside
the device lamp compartment as they may have stored energy.
WARNING: Use only SSXP300 Xenon lamp modules with this device.
Lamp Replacement Procedure:
•
Disconnect AC power cord.
•
Open lamp compartment door.
•
Remove lamp by grasping and pulling from plastic protective cover.
•
Install new lamp ensuring the glass face is pointed toward front panel.
•
Push lamp in until fully seated.
•
Close lamp compartment door.

9.2 Warranty

The light source carries a 3-year warranty from the date of shipment. The warranty covers
workmanship and all defects of material, excluding fiber optic cables. Should the device prove to have
such defects within three years of shipment, Sunoptic Technologies® will repair or replace the
device or component part without charge. Should your device need servicing under this warranty,
please contact Sunoptic Technologies® or a local distributor for return authorization procedure.
Please carefully pack the device in a sturdy carton and ship to the manufacturer. Include a note
describing the defects, your name, telephone number, and a return address. Warranty does not cover
product subjected to misuse, accidental damage, normal wear, and tear, or if transferred to a new
owner without authorization from Sunoptic Technologies®. This warranty gives you specific legal
rights, and you may have other rights which vary from state to state.
LIT-263 Sunoptic Technologies
Rev. A
®
Page 13 of 134
(English)