Publicité
Les langues disponibles
Les langues disponibles
2. Hand-wash the pads in water with pH-neutral soap.
3. Thoroughly rinse the pads.
4. Allow the pads to air-dry.
5. Reinstall the pads.
8.2
Replacing pads
1. Remove first the inner pad and then the outer pad
from each arm support. The pads are held in place
in the arm supports by burr fasteners.
2. Install the new pads in reverse sequence in each arm
support. Make sure that the pads are fitted right way
round.
The pads and the arm supports are color-
coded, with a blue dot for left and a red dot for
right.
3. Open the burr fasteners of the waist belt pad and
remove the pad.
4. Pass the burr fasteners of the new pad though the
openings in the belt web and close the fasteners.
8.3
Replacing arm-support strap
1. Open the burr fasteners at both ends of the arm-
support strap.
2. Remove the strap from the two tabs of the arm
support.
3. Position the top part of the magnetic catch at the
parked position on the arm support.
*2327944*
2327944
English
17
Publicité
