Listening To The Radio - Teac DR-H300p Manuel Du Propriétaire

1. Select FM or AM using the FUNCTION button (or the
TUNER button of the remote control unit).
2. Select the station you want to listen to (auto selection).
Hold down the TUNING button (+ or –) of the main unit for
more than 1 seconds.
"SEARCH . . ." appears on the display, and the unit starts
searching for a station.
When a station is tuned in, the tuning process will stop
automatically.
Repeat this step until the station you want to listen to is
found.
< If you want to stop the tuning process, press the TUNING
button.
Selecting stations which cannot be tuned automatically
(manual selection)
When the TUNING button is pressed momentarily, the
frequency changes by a fixed step.
Press the TUNING button repeatedly until the station you
want to listen to is found.
38

Listening to the Radio

STEREO/MONO Button
Pressing this button alternates between Stereo mode and
Mono mode.
STEREO
FM stereo broadcasts are received in stereo and the "ST."
indicator lights in the display.
< If the sound is distorted and the "ST." indicator flashes, the
signal is not strong enough for good stereo reception. In this
case, change to MONO mode.
MONO
To compensate for weak FM stereo reception, select this
mode. Reception will now be forced to monaural, reducing
unwanted noise.
If the reception is poor
For the best reception, rotate the FM or the AM antenna until
you get stations clearly.