Digital Audio Setup (Degital Output); Dolby Digital Setup (Dual Mono); 3D Processing; Night Mode (Dynamic Range Control) - Teac DR-H300p Manuel Du Propriétaire

DIGITAL AUDIO SETUP (DIGITAL OUTPUT)
OFF
Select this when you don't use the DIGITAL OUT or the HDMI
terminal.
No signal is output from these terminals.
ALL
Select this when the unit is connected to an audio component
equipped with a built-in Dolby Digital or DTS decoder via the
DIGITAL OUT or the HDMI terminal.
PCM only (Default)
Select this when the unit is connected to an audio component
such as amplifier/receiver, CD recorder or MD deck via the
DIGITAL OUT or the HDMI terminal.

DOLBY DIGITAL SETUP (DUAL MONO)

STEREO
Left channel is output from the left speaker, and right
channel is output from the right speaker.
L-MONO
Left channel is output from the front left and right speakers.
R-MONO
Right channel is output from the front left and right speakers.
34
Settings (Audio Setup Page)

3D PROCESSING

This setting provides following sound effects:

NIGHT MODE (Dynamic range control)

ON
Applies dynamic range control to Dolby Digital material,
reducing the volume of loud sounds, and increasing the
volume of quiet ones. This is useful for spoken word material,
etc. as well as nighttime listening.
OFF (default)
Turns off the audio dynamic compression.
< This function is effective only when playing back a DVD disc
recorded with Dolby Digital. This control has no effect on
other discs.
< The overall effect of this setting depends on many things: the
disc being played, the amplifier, and the speakers used for
reproduction.

AUDIO SYNC

This setting can cause delays in the sound signal in 10 ms
increments ranging from 0 ms to 200 ms (only for digital
signals recorded on a disc or stored in a USB device;
unavailable for analog signals coming from AUX 1 or 2).
Depending on the TV, it may take approximately 100 ms (0.1
sec.) for an image to appear after video signals are input,
causing the image to appear after the sound coming from the
DR-H300p is heard. If this happens or audio and video
synchronization creates a less than optimal viewing
experience, adjust the delay with the left (decrease) or right
(increase) cursor buttons.
OFF, CONCERT, LIVING ROOM, HALL, BATHROOM,
CAVE, ARENA, CHURCH