Installation Settings; Access; Configuration Of Detection Modes - Cordivari Claudia Manuel D'utilisation

= Reset to factory settings.
= Cancel reset to factory settings.
3- Press key for 5 seconds. The device returns to its initial confi -
guration and automatically switches to the initial display of user settings.
The following factory settings are reset:

12.Installation settings

12.1 Access

The installation settings can be accessed in 4 steps.
From Auto, Comfort, Eco or Frost Protection modes:
information display
1
Press for 5
1
seconds
Sequence of settings:
Confi guration of detection modes → PIN code lock → Reset of factory
settings
12.2 Confi guration of detection modes
• Detecting open window, enabling / disabling Auto mode
The automatic mode is the default active mode.
1- Press or .
= automatic mode enabled.
= automatic mode disabled
Cod. 1910000002086 - nv00
information display
2
Press twice
1
- 35 -
Parameters
Set Comfort temperature
Set Eco temperature
Boost time
Keyboard lock
User settings
Backlighting
Frost protection temperature
Maximum Boost time
Maximum ambient temperature for
automatic Boost shutdown
Press to exit user settings.
3
Press for 10
seconds
2- To save and automatically move to the next setting, press
exit user settings, press 3 times.
• Presence detection, enabling/disabling
1- By default, presence detection is enabled.
2- Press or .
= automatic mode enabled
= automatic mode disabled.
Important: If the presence sensor is disabled and the device is in Auto
mode:
Whatever the current program, the device will not automatically lower
the temperature and will not switch to Frost protection after 72 hours of
absence.
If automatic programming was active before disabling the sensor, it
is disabled when the presence sensor is disabled. The next time the
presence sensor is reactivated, the device will apply the smart program
used before deactivation and defi nes a new learning scheme.
English
Factory settings
Operation
19°C
15°C
60 min.
Disabled
L3
7°C
60 min.
25°C
4
= Installation
settings
Press briefl y
. To