On/ Standby Mode; Selection Of The Operating Mode - Cordivari Claudia Manuel D'utilisation

English
• Indicators on the device
1
2
3 2 2
4
1. Boost indicator
2. Consumption indicator
3. Heating indicator
4. Days of the week (1=Monday ... 7= Sunday)
5. Temperature setting
6. Presence detection indicator
7. Open window detection indicator
8. Keyboard locked
9. Radio transmission indicator
10. Operating modes:
Auto mode
Comfort mode
Eco Mode
Frost protection mode
Time and day setting mode
Programming modes
Settings
Important: In Auto, Comfort, Eco and Standby modes, the backlighting
turns off automatically after 20 seconds if no buttons are pressed. It is
necessary to reactivate it by pressing a button on the keyboard before
making settings.
Important: Before performing any setting procedure, make sure the
keyboard is unlocked.

10.2 On/ standby mode

Switching on function
When using this function for the fi rst time, press the power switch under the
fan so that it switches to I, to start the device.
The device is in Auto mode.
Note: The heating indicator light will only light up if the detected temperature
is lower than the preset temperature. If the ambient temperature is lower
than the set temperature by 2°C, the fan turns on.
10
6
5
Standby function
When the switch is on I, press it to switch to the other position.
9
8
7
Note: The settings applied during operation are saved automatically and
will be applied to the next use.
Important: Before performing any setting procedure, make sure the
keyboard is unlocked.

10.3 Selection of the operating mode

The button allows adapting the operating program of the device to
your needs, depending on the season or the presence or absence of
people in the house.
Press the button
Mode sequence:
Auto
General description of modes:
• Auto mode
In automatic mode, the device automatically switches from Comfort mode
to Eco mode according to the set program.
3 diff erent cases depending on the settings:
1. Weekly and daily program
The device has been programmed and is performing Comfort and Eco mode
commands in line with the selected settings and time periods.
2. Auto-Programming
If you do not want to use the programming function. Devices equipped
with a presence sensor are supplied with the self-learning mode enabled
by default (i.e., there is no need to change any settings).
3. No program
If the weekly and daily programs are not enabled, the factory settings of
the device activate the non-stop Comfort mode, 7 days a week. Boost
periods are managed automatically.
- 26 -
once or several times to select the desired mode.
Comfort Eco
3
Cod. 1910000002086 - nv00
Frost Protection