Cordivari Claudia Manuel D'utilisation page 30

English
• Potential program changes
If the default times for programs P1, P2 and P3 are not suitable for your
routine, you can change them.
Changing programs P1, P2 or P3.
If you change the times of programs P1, P2 or P3, the change will be
applied to all days of the week where P1, P2 or P3 have been set.
1- After setting the time and day, go to step 2. From Auto, Comfort, Eco or
Frost Protection modes, press
to the time setting symbol , press briefl y
1
2- Press or . The cursor moves to prog.
1 1
3- With or , select P1. P1 will fl ash. Press
to make changes.
1 1
4- The start time P1 (which is 6 am by default) will fl ash. Press
to change the time with 30-minute increments. Press
5- The end time P1 (which is 10 pm by default) will fl ash. Press
to change the time with 30-minute increments.
Press to save.
for 5 seconds. When the cursor moves
.
for 5 seconds
or
to save.
6- Press to exit programming mode and return to Auto mode.
Note: Without pressing any key, the Auto mode is restored after a few
minutes.
• Selecting and assigning programs
Preliminary information:display area
The numbers from 1 to 7 correspond to the days from Monday to Sunday.
1- After setting the time and day, the cursor moves automatically under
PROG.
From Auto, Comfort, Eco or Frost Protection mode, press
conds. When the cursor is positioned under the time setting symbol
press again .
The days of the week are all displayed. The default Auto program is di-
splayed
2- Press or The default assigned program, Auto, will fl ash. Then
it is assigned to all the days of the week.
r
3- Select the desired program for the day with
pressing .
or
4- The program assigned to the second day of the week (Tuesday) will
fl ash.
- 30 -
2
1 2 3 4 5 6 7
1 2 3 4 5 6 7 1 2 3 4 5 6 7
1 2 3 4 5 6 7
Cod. 1910000002086 - nv00
for 5 se-
,
or . Save by