Publicité
Les langues disponibles
Les langues disponibles
Disconnecting the belt clip
Turn the belt clip to the right (in the direction of ™) (1) and take it out of the opening ().
,
(Fig. )
Connecting the neck strap
Insert the small pin at the end of the neck strap into the opening on the back of the parent
,
unit (1). Turn the neck strap to the left () until it locks into position ('click'). (Fig. )
Disconnecting the neck strap
Turn the neck strap to the right (in the direction of ™) (1) and take it out of the opening ().
,
(Fig. 5)
paging function
If you have misplaced the parent unit and its volume is switched off, you can use the page button on
the baby unit to locate the parent unit.
1
Briefly press the page button on the baby unit. The parent unit then produces a paging alert
tone. (Fig. 6)
To stop the paging alert tone, briefly press the page button again or press any button on the
parent unit.
Note:If you press the page button too long, the parent unit will not produce the paging alert tone.
reset function
This function allows you to reset the parent unit and baby unit to the default settings. You can use
this function if problems occur that cannot be solved by following the suggestions in chapter
'Frequently asked questions'. You have to reset each unit separately.
1
Press and hold the on/off button for seconds to switch on the units.
Press and hold the " -volume" button as soon as the connection lights on the units start
burning.
The units have now been reset to the default factory settings.
,
Default settings
Parent unit
,
-
Loudspeaker volume: 1
-
Microphone sensitivity: 3
Baby unit
,
-
Loudspeaker volume: 3
-
Nightlight: off
Cleaning and maintenance
Do not immerse the parent units and the baby unit in water and do not clean them under the
tap.
Do not use liquid cleaners or aerosol cleaners.
1
Unplug the parent units and the baby unit.
Clean the parent units and the baby unit with a damp cloth.
EngliSh
1
Publicité
