Button Function - Franke FSN 908 BK A Mode D'emploi Et Installation

USE
A

Button Function

A
Turns the suction motor on and off.
B
Decreases the working speed.
C
Increases the working speed.
D
Activates Intensive speed from any other speed,
with the exception of Delay and 24H. This speed
is set to operate for 10 minutes, after which the
system returns to the speed that was set before.
Suitable to deal with maximum levels of cooking
fumes.
Pressing and holding the button for approximately
5 seconds, with all functions turned off
(Motor+Light), Enables / Disables the Activated
Charcoal Filter alarm.
E
Starts the Motor in Air Change mode, at a speed
that allows suction 10 minutes for hour, after
which the Motor will stop.
F
Activates automatic switch-off with a 30' delay.
Suitable to complete elimination of residual
odours. Can only be activated with the motor
turned on at a Speed other than 24H and Intensive.
Press and hold the button for approximately 5
seconds to Enable / Disable the Remote control.
Reset
G
Performs a
when the Button is pressed for approximately 3
seconds.
H
Decreases the intensity of the Lighting each time
the Button is pressed, in cycle.
I
Turns the lighting system on and off at maximum
intensity.
L
Increases the intensity of the Lighting each time
the Button is pressed, in cycle.
Keyboard Lock: it is possible to lock the keyboard, for example when cleaning the Glass surface, when the
Hood has Motor and Lights turned off.
Press A for approximately 5 Seconds to enable or disable the Keyboard Lock, which is always confirmed
by a Beep and an animation on the display motor bar.
EN
A B C E
D
B C D E
Control panel
of the Filter saturation alarm
F
G I
H
F G
H I
Display
-
The number of lighted segments decreases.
The number of lighted segments increases.
I
The indicator flashes and all the segments on the
Display are lit.
It is disabled by pressing the Button.
2 Flashes of symbol C – Alarm Enabled.
1 Flash of symbol C – Alarm Disabled.
24
Displays and the segments on the Display all light
up and then turn off one at a time in cycle.
It is disabled by pressing the Button.
Clock
Displays a flashing
It is disabled by pressing the Button.
2 Flashes of the Horizontal Bars – Remote Control
Enabled.
1 Flash of the Horizontal Bars – Remote Control
Disabled.
After 100 hours in operation the
displayed to indicate saturation of the Metal Grease
Filters.
After 200 hours in operation the letter
to indicate saturation of the Activated Charcoal
filters.
L
L
symbol.
Drop
symbol is
C
is displayed
1 10