Franke FSN 908 BK A Mode D'emploi Et Installation page 8

Fitting the hood body
• Open the doors/the door (See section Open
Panels).
• Remove the Metal grease filters using the
handles provided.
• Adjust the two screws Vr, in the brackets 11a,
so that they are at the start of their travel.
• Hook the hood body to the two brackets 11a.
• From the inside of the hood body, turn screws
Vr to level the hood body itself.
• Fasten the safety screw 12a.
• Close the doors/the door again.
Connections
DUCTED VERSION AIR EXHAUST SYSTEM
When installing the ducted version, connect the
hood to the chimney using either a flexible or
rigid pipe ø 150 or 120 mm, the choice of which
is left to the installer.
• To install a ø 120 mm air exhaust connection,
insert the reducer flange 9 on the hood body
outlet.
• Fix the pipe in position using sufficient pipe
clamps (not supplied).
• Remove any activated charcoal filters.
EN
ø 120
ø 150
9
8 8