Publicité
Les langues disponibles
Les langues disponibles
840105800 ENv05.qxd 12/4/02 9:47 AM Page 4
Installation
1. This can opener is designed to be
installed under a cabinet. When
selecting a location for installation,
please consider the following:
• An electrical outlet should be within
easy reach of the plug so that the
cord does not drape over a heating
or cooking appliance, a sink or
basin, or get in the way of your
normal work space.
• Do not install the can opener above
a cooking or heating unit, such as a
stove, or above a sink or basin.
2. Position the mounting bracket on
underside of cabinet, at least 4 inch-
es from wall, and 1 inch from front of
cabinet edge. Use a sharp nail or drill
bit through bracket holes to mark
cabinet for drilling holes. (See Figure
1.) Drill holes through cabinet.
3. Place mounting bracket on under
side of cabinet. Hold nut in screw
hole with finger. Insert screw from
inside cabinet and tighten with
screwdriver. (See Figure 2.)
4. Repeat with remaining screws. Place
electrical cord through slot on back
of can opener. Slide can opener into
place from back of bracket. Slide for-
ward until it snaps into place.
NOTE: Based on the variety of cabinet sizes, the enclosed
screws for mounting may not work. Longer or shorter screws
may be purchased at your local hardware store.
Figure 1
Figure 2
4
How to Use Your Can Opener
This is new technology and does not need a magnet arm.
1. Plug cord into electrical outlet.
2. Move switch to OFF position. (See Figure 3.)
Center the rim of can BEHIND, UP and AGAINST lid opener.
(See Figure 4.)
OFF
position
Figure 3
3. Hold can against opener support. (See Figure 5.)
DO:
Support
Figure 5
Lid
Opener
Figure 4
DO NOT:
5
Publicité
