Publicité
Les langues disponibles
Les langues disponibles
INSTALL RANGE HOOD
BODY
1. Thread (3) M5 x 15 mm screws into range
hood body, but do not tighten. Fig.13.
2. Leave a 5/16" gap between underside of
washers and mounting surface.
3. Lift range hood body into position under
downrod bracket.
4. Turn body until (3) M5 screws engage
with slots in mounting bracket. Tighten
screws. Fig.14.
CAUTION: To ensure that range hood body
is secure, make sure this screw is installed
and securely fastened!
5. Install and fasten (1) M5 x 15 mm screw
through the hole provided in one leg of the
mounting bracket and into the range hood
body.
6. Connect male and female electrical
connectors together.
7. Tuck excess wire under mounting
bracket.
8. Align wiring cover with holes on downrod
mounting bracket. Fig.15.
9. Fasten with (2) M5 x 15 mm screws.
10.Install filter assembly.
11.Turn on power at service entrance and
check operation of range hood.
WIRING
COVER
- 10 -
M5 x 15 mm
SCREWS
(3)
FIG. 13
M5 x 15 mm
SCREW
(1)
FIG. 14
M5 x 15 mm
SCREWS
(2)
FIG. 15
Publicité
