Publicité
Les langues disponibles
Les langues disponibles
CAUTION: Lines coasts after turn off.
Do not use under wet conditions.
CAUTION: Inspect area to be trimmed and remove any wire, cord,
or string-like objects which could become entangled in the rotating
line or spool. Be particularly careful to avoid any wire which might be
bent outwardly into the path of the tool, such as barbs at the base of
a chain link fence.
Proper Cutting Stance
Weight should be balanced with both feet on solid
ground.
Basic Cutting Procedure
Slowly swing trimmer side-to-side as shown.
EDGING
To convert for maintenance edging, turn off the tool. Holding the
trimmer with one hand, push in the head rotating button and rotate
the head 180 degrees counter-clockwise. The head will be locked
in the edger position. Lower the edge guard to start edging. (Fig.
7)
Head Rotating
Button
Return to trimming position by turning the tool off. Push the head
rotating button and rotate the trimmer head clockwise 180 degrees
until until it locks in the proper trimming position. When using the
tool in the trimmer mode you may choose to lift the edge guard up
out of the way.
WARNING: Do not trim near electrical wires or buildings.
WARNING: Do not allow familiarity with this type of product to
make you careless. Remember that a careless fraction of a
second is sufficient to inflict serious injury.
Do not operate a string trimmer in a tree, on a ladder, or on a
scaffold. This is extremely dangerous.
Wear non-slip gloves for maximum grip and protection.
OPERATING
CUTTING INSTRUCTIONS
LINE FEEDING
Your trimmer uses .065" diameter nylon line to cut grass and weeds
quickly and easily. In time, the tip of the nylon line will become worn
and the auto feed mechanism will automatically feed a fresh length of
line. The cutting line will wear faster if the cutting is done along
sidewalks or other abrasive surfaces or heavier weeds are being cut.
The line will extend approximately ¼ in. with each stop and restart of
the trimmer. Do not bump unit on ground in attempt to feed line or
for any other purpose.
If your trimmer line hits sharp or abrasive objects, such as stones,
metal pieces, or concrete, the trimmer line can be cut too short to
continue trimming. In this case, you can manually extend the line:
MANUALLY EXTENDED LINE ( Fig. 8)
1.
REMOVE THE BATTERY PACK.
2.
Press the line-feeding button with one hand while pulling the line
out with the other.
3.
Press the button repeatedly to release line to the proper length.
Each press of the button will release approximately 1/4 inch of
line. (Note: Release only enough line to extend just beyond the
blade. If too much line is released, the blade will be unable to cut
Edge Guard
it to the correct working length and it may become tangled on the
rotating shaft.)
4.
Install the battery pack.
5.
Restart the trimmer and return to normal operation.
Fig. 7
6
Line
Feeding
Button
Fig 8
Pull
Publicité
