Installation Into A Threaded 2'' Wall Conduit (With Pf10R294 Only For Concrete Pool); Installation Into A Ccei Wall Inlet - ccei Mini Brio + Notice Technique

Technical information sheet
3.3. Installation into a threaded 2'' wall conduit (with PF10R294 only for concrete
pool)

3.4. Installation into a CCEI wall inlet

If you prefer to install a Mini Brio + & Switch into a CCEI wall inlet (see next images), you have to place the O-ring inside the
wall inlet (use some grease during the installation). Once compressed during tightening, the O-ring allows a dry sheath between
the back of the light and the connection box above the water level.
This allows to increase the watertighness of the connection box and limit frost risk in sheath. This O-ring will not guarantee
the watertightness of the installation. It will improve the protection of the connection box. If the light is not well screwed and
under the water level, the sheath will be filled directly with water.
One-piece or concrete pool (PF10R291)
Liner pool (PF10R292)
3.4.1. Disconnectable version - Mini-BRiO Switch
Use the Mini-BRiO Switch light by reusing the existing cable. Do do that, proceed as follows:
Mini Brio + & Switch M7 & X8
1. Screw the light in the 1,5" adapter then pass the cable
though the wall conduit
2. Push and screw it thoroughly
A. Set the O-ring in the wall inlet and pass the cable
B. Push and screw the light
C. Use the supplied tool to screw the light thoroughly
A. Set the O-ring in the wall inlet and pass the cable
B. Push and screw the light
C. Use the supplied tool to screw the light thoroughly
D. Clip the supplied flange on the wall inlet
1. Cut the cable behind the existing light
2. Strip the wires (be careful not to strip them too much)
3. Pass the cable through the cable gland behind the light. Check the
watertight seal is in position (A)
4. Grease the seal before assembly
5. Connect the two wires to the lugs at the back of the light (B)
6. Close the back cap using nut (C) and screw in the assembly
7. Screw the light back into the 1.5" backflow
If you use a trim. Remember to pass the light
though the trim before connecting the light to
the power supply wire
v1.0EN
3