Planning - Electrolux 600cfm Instructions D'utilisation

List of Included Parts for model
EI06DDPIKS:
• Blower Assembly
• Duct Transition
• 2-1/4" Hex Head Screws for mounting lower
side plate to chassis
Installation Planning
A qualified technician must complete the installation
of this appliance.
The Telescoping Downdraft must be modified to install
the Internal Blower System. The following steps will
cover those modifications and the installation of the
Internal Blower System. It is easier to modify the
unit on a table or on the floor before installing into
the countertop.
Remove Duct Transition
1
Remove Control Box Cover
2
3 Remove Romex Cable Clamp
Rotate the Blower (if needed)
4
5 Make Electrical Connection from Blower to
Control Box
6 Replace Control Box Cover and Attach Blower
to the Chassis
Make Electrical House Connection
7
8 Install Duct Transition
Specifications and Dimensions
NOTE
All dimensional tolerances are +1/16", -0"
unless otherwise stated.
IMPORTANT
Local building codes must be followed in specifying
approved type and specification of ALL duct used.
IMPORTANT
Retain all packing and materials until the
telescoping downdraft and all components
have been installed.

Planning

5