Installation - Electrolux 600cfm Instructions D'utilisation

Cut Countertop Opening
- Lay out and cut the cooktop cut-out far enough
forward so downdraft will fit behind it (refer to cooktop
installation instructions).
- Set cooktop in place and slide it as far forward
as possible. Center and square it with edges of
countertop.
A ½" minimum
clearance behind
cutout must be
maintained for
proper installation.
Template
- Place the template against the back flange of the
cooktop and center it. Trace around template to mark
the downdraft opening.
- Remove cooktop from countertop.
- Cut downdraft opening. Be careful not to chop edges
of countertop. Mask the countertop to help prevent
scratching the surface.
- A ½" minimum clearance behind cutout must be
maintained behind the telescopic downdraft for proper

installation.

NOTE
Cabinet constructions may vary. Be sure to
take cabinet frame members into account. They
may have to be removed or relocated. Do not
compromise the structural integrity of the cabinet
in doing so.
Install Electrical Wiring
- Mount a standard wiring box, with 3-pronged
grounded receptacle, inside the cabinet. Make sure
the downdraft's power cord can easily reach it.
- Run appropriate power cable into cabinet and
connect it to receptacle.
Installation
Install Duct Transition to Blower
Install the duct transition on the blower, using the
three wide head Phillips screws. It is recommended
for all duct joints, the seam between the blower and
the duct transition should be sealed with duct tape
over the screws.
(3) Wide Head
Phillips Screws
Duct Transition
11
Blower