Publicité
Les langues disponibles
Les langues disponibles
How to Brew a Single-Serve Pack
w WARNING
Burn Hazard.
If overflow occurs, unplug and allow coffee maker to cool.
To avoid hot coffee overflowing:
• Fill reservoir with cold water with MIN of 15 oz. (444 ml) and MAX
40 oz. (1.2 L).
• Always insert funnel before single-serve pack holder.
• Fully insert cup or travel mug on drip tray.
• Do not lift lid during brewing process.
• If brew process is stopped early, you must complete the brew
process to empty water for cup size selected. Place a large mug on
drip tray/cup rest. Press BREW REG or BREW BOLD button. Failure to
drain unit can cause next cup brewed to overflow. Follow "How to
Purge" on page 6.
w CAUTION
Cut Hazard.
Removable single-serve pack holder has a sharp needle. Piercing
needle on underside of lid also is sharp. Use caution when handling.
NOTES:
• Use only cold water in reservoir. Do not use hot water.
• Do not reheat coffee in machine.
• Do not use creamer or nondairy creamer in reservoir.
• After brewing hot cocoa single-serve packs, brew a water-only
cycle without a single-serve pack to avoid possibility of clogging
piercing needle. Always rinse funnel to prevent clogging.
• Cup size cannot be changed once brew button has been pressed.
• Press BREW REG or BREW BOLD button again to STOP brewing
midcycle. See warning statement above.
• If brew indicator light flashes three times, lid is not closed. Lower
lid until it clicks to lock. Press BREW REG or BREW BOLD button.
• Do not brew coffee without removable needle holder locked into
place.
• Single-serve pack should always be removed 1 hour after brewing
to prevent a clogged needle.
4
1. Plug into outlet.
2. Lift lid latch until lid clicks into place.
3. Insert funnel in opening. Place gray
removable single-serve pack holder
in funnel, aligning handle with funnel
handle.
4. Place a pack into single-serve pack
holder. Do not remove foil.
5. Close lid and snap in place to pierce
single-serve pack.
6. Remove water reservoir and lid. Add
water up to at least MIN fill line (15 oz.
[444 ml]) or MAX fill line (40 oz. [1.2 L]).
7. Place lid on water reservoir and then
slide onto coffee maker.
8. Use cup rest for a cup or mug and
remove cup rest for a travel mug. Press
cup size button to change cup size.
9. Press BREW REG or BREW BOLD button
to start brewing. The brew indicator
light will light up to show that coffee
maker is brewing. The coffee maker will
shut off automatically when brewing is
complete. Unplug.
10. Funnel and single-serve pack holder
should be rinsed after every use.
NOTE: Steps 6, 7, and 8 do not have
to be repeated for each cup brewed.
Repeat when water goes below MIN fill
line or when water icon (
3
4
6
) is flashing.
8
Publicité
