Westfalia WS920 Instructions Originales page 19

attempt to lift the spinning disc out of the cut, this may cause
kickback. Verify and remove the cause for the stoppage.
 Do not turn on the electric tool while the disc is in the
workpiece. Allow the disc to reach full speed before carefully
resuming the cut. Otherwise the disc may jam, jump out of the
cut or kick back.
 Support sheets or large workpieces to reduce the risk of a
kickback caused by the disc being wedged in the workpiece.
Larger workpieces may deform under their own weight. The
workpiece must be supported on both sides, on the edges as
well as close to the cut.
 Be especially careful when undertaking "pocket cuts" in
existing walls or other areas which cannot be overlooked.
When plunging into the wall the disc can kick back when
hitting gas or water pipes, wires or other objects in the wall.
 Make sure the cord cannot get caught in any way. Do not
wind the cord around the electric tool and do not bend it. Do
not jam the cord or pull cord around edges. Do not pinch the
power cord in any way and keep it away from hot surfaces.
 Before cleaning or maintaining, first disconnect the plug from
power mains.
 Do not continue using the electric tool if it was damaged or
the tool was dropped or immersed in water. Please contact
our customer support service.
Safety Notes
15