Westfalia WS920 Instructions Originales page 15

 The maximum allowed speed for an attachment must be at
least as high as the no load speed noted on the electric tool.
Attachments spinning faster than allowed may be destroyed.
 Outside diameter and thickness of the tool bit must corre-
spond to the dimensions stated on your electric tool. Attach-
ments of the wrong size cannot be shielded and controlled
properly.
 Discs, flanges, and other attachments must precisely fit the
spindle of your electric tool. Tool bits which do not precisely fit
the spindle turn irregularly, vibrate and can cause loss of
control.
 Do not use attachments which have been damaged in any
way. Check attachments such as grinding discs for missing
bits and cracks. If the tool or the attachment has been
dropped, check it for damage or use an undamaged item.
After the attachment has been checked and attached, please
keep yourself and other persons out of the rotating area of the
attachment and let the machine run at full speed for one
minute. Most damaged attachments and tools will fail within
that time.
 Wear personal protective equipment. If necessary and
depending on the application, wear full face protection,
eye protection, or safety goggles. If necessary, wear a
dust mask, ear protection, safety gloves or a safety
apron which protect you from flying fragments. The
eyes must be protected from flying debris, which are
generated by many operations. Dust must be filtered
out by the dust mask or breath protection. If you are exposed
to high levels of noise for extended amounts of time, your
hearing may be damaged.
 Implement additional safety measures to protect the operator
from the effects of vibration, such as servicing the power tool
and application tools, keeping their hands warm, and organis-
Safety Notes
11