Operation Via Remote Control - Klarstein BORMIO SMART Mode D'emploi

OPERATION VIA REMOTE CONTROL

Note: When using the remote control, do not remove it more than 6 meters (19 feet)
from the unit, making sure that the remote control is always oriented in the direction of
the unit.
Start the device
When you press the power button on the remote control, the screen of the remote control
will turn on, the flame will ignite, and the flame icon will appear on the LCD screen.
Week, time (24h system) and temperature display will be displayed normally. If you
press the power button again, the LCD screen of the remote control will turn off.
Flame and coal control switch
• Pressing the button once when the unit is turned on will extinguish the flame and the
coal bed, and the LCD screen will no longer display the
• If you press this button again, the flame and the coal will start again and the screen
will show the icon. When this button is pressed, the unit will beep once.
Adjust the flame brightness
Press this button to adjust the flame brightness. When this button is pressed, the unit will
beep once.
Adjust the brightness of the coal bed
To adjust the brightness of the coal bed, press this button. The unit will beep once when this
button is pressed.
icon.
EN
23