mspa Carlton M-CA061 Manuel D'entretien page 4

Masquer les pouces Voir aussi pour Carlton M-CA061:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

An adequate draining system must be provided around the spa to deal with overflow water.
To reduce the risk of injury:
a) Lower water temperatures are recommended for young children and when spa use exceeds 10 minutes. In
order to avoid the possibility of hyperthermia (heat stress) occurring, it is recommended that the average
spa-pool water temperature does not exceed 40°C (104°F).
b) Since excessive water temperatures have a high potential for causing fetal damage during the early months of
pregnancy, pregnant or possibly pregnant women should limit the spa water temperature to 38°C (100°F).
c) Before entering the spa or hot tub, the user should measure the water temperature with an accurate thermometer
since the tolerance of water temperature regulating devices may vary.
d) The use of alcohol, drugs or medication before or during spa use may lead to unconsciousness with the possibility
of drowning.
e) The use of alcohol, drugs or medication can greatly increase the risk of fatal hyperthermia in spas.
f) The causes and symptoms of hyperthermia may be described as follows: Hyperthermia occurs when the
internal body temperature reaches a level several degrees above the normal body temperature of 37°C
(98.6°F).The symptoms of hyperthermia include an increase in the body's internal temperature, dizziness,
lethargy, drowsiness, and fainting. The effects of hyperthemia include a failure to perceive heat; a failure to
recognize the need to exit the spa; an unawareness of impending hazards; fetal damage in pregnant women;
a physical inability to exit the spa; and unconsciousness resulting in the danger of drowning.
g) Obese persons or persons with a history of heart disease, low or high blood pressure, circulatory system prob
lems, or diabetes should consult a physician before using a spa.
h) Persons using medication should consult a physician before using a spa since some medication may induce
drowsiness or affect the heart rate, blood pressure, or circulation.
i) Check with a doctor before use if pregnant, diabetic, in poor health, or under medical care.
People with an infectious disease should not use a spa or hot tub.
To avoid injury, exercise care when entering or exiting the spa or hot tub.
Water temperatures in excess of 40°C (104°F) may be injurious to your health.
Never use a spa or hot tub alone or allow others to use the spa alone.
Do not use a spa or hot tub immediately following strenuous exercise.
Spa heat in conjunction with alcohol, drugs, or medication can cause unconsciousness.
Exit immediately if uncomfortable, dizzy, or sleepy. Spa heat can cause hyperthermia and unconsciousness.
To prevent freezing, the spa must not be exposed to temperatures below 0°C (32°F) if there is still water in the pool.
It is helpful to place a temperature barrier mat between the spa pool and the ground. A similar mat made of foam or
any other material with a heat barrier function can also be used. Do not turn on the spa when the water is frozen.
Never pour water with a temperature higher than 40°C (104°F) into the spa directly.
Always unplug the product from the electrical outlet before removing, cleaning, servicing or making any adjustments.
Never jump or dive into a spa or any shallow body of water.
No part of the electric appliance is to be located above the bath during use.
Do not bury the electrical cord. Locate the cord where it will not be damaged by lawn mowers, hedge trimmers or
any other equipment.
Do not attempt to plug in or unplug the product while standing in water or when your hands are wet.
Do not use the spa if it is damaged on delivery and/or if it malfunctions in any way.
Contact the MSpa service center for further instructions.
Keep all pets away from the spa to avoid any damage.
Do not add bath oil or bath salt to the spa water.
Avoid putting your head under the water at all times.
Avoid swallowing the spa water.
The spa contains a UVC emitter. To replace or repair the UVC emitter, contact a professional operator.
4

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Otium m-ot061

Table des Matières