mspa Carlton M-CA061 Manuel D'entretien page 16

PROBLEM
Power socket failure
PRCD is off
NO DISPLAY ON THE
Press the Reset button, controller is
CONTROL PANEL
not displayed
PRCD broken
Spa in&outlet connection not
securely tight
SPA LEAKING
Drainage valve is not closed completely
Water leaks from the spa pool body
Temperature set too low
Dirty filter cartridge
NOT HEATING
Water level is not at the minimum
PROPERLY
water line
Heater failure
Filter pump DOES NOT WORK
Air valve is loose
SPA LOSES AIR
Hole or split on the spa tub
Water has been used for long
period of time
Insufficient filteration time
WATER NOT CLEAN
Dirty filter cartridge
Improper water maintenance
SPA TUB IN AN
Extra air pressure due to strong sunlight
ABNORMAL SHAPE
BUBBLE AIR BLOWER Auto-off 10 minutes
DOES NOT WORK
Internal parts damaged
Filter cartridge clogged by dirt or
FILTER PUMP DOES
other objects
NOT WORK
Filter system failure
Water level is below the minimum
water line
OZONATOR FAILURE
Internal parts damaged
Filter pump does not work
Spa doesn't start inflation.
AUTO-INFLATION
FAILURE
Spa doesn't stop inflation.
Water level is not at the minimum
water line
JET FUNCTION
Water inlet blocked
FAILURE
Filter pump does not work
CAUSE
Change a socket or repair the socket before use
Reset the PRCD by following the PRCD Testing section
Contact the MSpa Service Center
Contact the MSpa Service Center
Tighten the in&outlet connection
Close the drainage valve. Contact the MSpa Service Center, if spa is still leaking
Repair the leaking hole/split with the repair kit material
Set a higher temperature
Clean or replace the filter cartridge
Add more water to the minimum line
Contact the MSpa Service Center
Refer to the "FILTER PUMP DOES NOT WORK" section
Inflate the spa till Yellow section of the manometer is pushed out. Make sure the
valve is screwed tightly. Replace the valve if necessary.
Fill a squirt bottle with soapy water and spray on the seams. If there is a leak, small
bubbles will come out. When you have located the leak, clean and dry the leaking
area, then use the repair patch supplied with your spa. Check the repair section on P15.
Change the water
Extend the filtration time
Clean or replace the filter cartridge in time
Refer to the chemical manufacturer's instructions
Check the air pressure and release air if necessary
During hot weather, it is advisable to check whether some air should be released to avoid
any possible damage to the spa pool.
Wait for 10 minutes and turn on the Bubble button again
Contact the MSpa Service Center
Clean or replace the filter cartridge
Contact the MSpa Service Center
Add water above the minimum line
Contact the MSpa Service Center
Refer to "FILTER PUMP DOES NOT WORK" section
Contact the MSpa Service Center
Contact the MSpa Service Center
Add more water above the minimum line
Clean the filter pump & jet pump inlets
Refer to "FILTER PUMP DOES NOT WORK" section
SOLUTION
16