Bimar VM43 Notice D'instructions page 16

For assembly, refer to below pictures.
Ventilator
1. Fasten the rear grid (5) to the motor casing, positioning the corresponding
pins and holes, and lock using the appropriate ring nut (4).
2. Insert the fan (3) on the motor shaft (6) and lock with the appropriate ring
nut (2) turning it tightly anti-clockwise.
3. Couple the front grid (1) with the rear grid (5) and lock with the plastic ring
and ensure the fastening with the appropriate locking screws (11). Having
done this, check that the protection grid is firmly coupled and fastened to
the motor.
Wall installation
 The appliance must only be used if secured to a wall: the wall must be flat,
smooth, very stable (as the appliance could tip over) and resistant.
 Position the appliance far from other sources of heat, inflammable materials
(curtains, carpets, etc.), inflammable gases or explosive materials (spray cans).
 If the appliance is fitted to a wall, the same must be made of masonry and/ or
of resistant material (not of wood or synthetic material); follow the indications
below for installation:
- The wall fan must be installed at least 2 m above the floor
- Place the metal plate to the wall, make 3 holes in the wall, as far apart as in
Figure 1 (before drilling holes is good to measure the distance between the
slots above), insert the screw anchors into the holes, place the plate metal and
tighten the screws as shown in Figure 2, attach the motor housing to the plate
and secure it with the supplied screw (8).)
Fig.1 Fig.2
16/48
Fig.3