DeWalt DW511 Guide D'utilisation page 7

Side Handle (Fig. A, C)

WARNING: To reduce the risk of personal injury,
ALWAYS operate the tool with the side handle
properly installed and tightened. Failure to do
so may result in the side handle slipping during tool
operation and subsequent loss of control. Hold tool
with both hands to maximize control.
A side handle may be supplied with this hammerdrill. It
4
clamps to the front of the gear case as shown in Figure C
and can be rotated 360˚ for right- or left- hand use. Rotate
clockwise until securely tightened.
Fig. C
6
4
Hammer/Drill Selector (Fig. A)
To switch the tool from the drilling mode to the hammering
mode (or vice-versa) rotate the selector dial
applicable symbol shown in Figure A. For straight drilling,
align the drill bit symbol toward the chuck. For hammering,
align the hammer symbol with the lever, as shown.
nOTE: The selector must be in either drill or hammer/drill
mode at all times. There are no operable positions between
the two modes.
Chuck Key Holder (Fig. D, E, F)
1. Push double-hole end of holder through the slot in
other end of holder (Fig. D).
2. Slip loop over electric plug and draw loop tight around
cord (Fig. E).
3. Push ends of chuck key handle (long end first) through
two holes in end of holder (Fig. F).
Fig. D Fig. E
Fig. F
Keyed Chuck (Fig. A)
Open chuck jaws by turning collar with fingers and insert
shank of bit about 3/4" (19 mm) into chuck
chuck collar by hand. Place chuck key in each of the three
holes, and tighten in clockwise direction. It's important to
tighten chuck with all three holes to prevent slippage. To
release bit, turn chuck key counterclockwise in just one hole,
then loosen the chuck by hand. Any authorized D
service center can install a keyless chuck in place of a
keyed chuck.
Depth Rod (Fig. A, C)
To adjust the depth rod, loosen the side handle
move depth rod
of the rod and the end of the bit equals the desired drilling
depth. When drilling with depth rod, stop when end of rod
reaches surface of material.
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Proper Hand Position (Fig. G)

WARNING: To reduce the risk of serious personal injury,
ALWAYS use proper hand position as shown.
5 on the

WARNING: To reduce the risk of serious personal
injury, ALWAYS hold securely in anticipation of a
sudden reaction.
Proper hand position requires one hand on the main
handle 8
Fig. G
4

WARNING: To reduce the risk of personal injury,
ALWAYS ensure workpiece is anchored or
clamped firmly. If drilling thin material, use a wood
"back-up" block to prevent damage to the material.

WARNING: To reduce the risk of personal injury,
ALWAYS operate the tool with the side handle
properly installed. Failure to do so may result in
the side handle slipping during tool operation and
subsequent loss of control. Hold tool with both hands
to maximize control.
6 so that the distance between the end
and one hand on the side handle
English
. Tighten
7
WALT
e
and
4
4 .
8
5