Télécharger Imprimer la page

Star UltraMax UM1833A Instructions D'installation Et D'utilisation page 8

Publicité

Les langues disponibles

Les langues disponibles

SAFETY OPERATING INSTRUCTIONS
The information contained in this section is provided for the use of qualified operating personnel.
Qualified operating personnel are those who have carefully read the information contained in
this manual, are familiar with the functions of the oven and/or have had previous experience
with the operation of the equipment described. Adherence to the procedures recommended
herein will assure the achievement of optimum performance and long, trouble-free service.
STACKING INSTRUCTIONS
The following instructions should be followed when stacking more
than one unit.
Single Oven (or Bottom) Cart Install:
1. Remove door, conveyor, and finger assemblies.
2. Unbolt unit from shipping crate (4 bolts).
3. Turn unit on front as shown.
4. Thread the four legs into the bottom of the oven.
5. CAREFULLY lift oven upright.
Stacked Oven Install Preparation:
1. Remove door, conveyor, and finger assemblies.
2. Unbolt unit from shipping crate (4 bolts).
3. Turn unit on front as shown.
4. Remove top of lower oven (4 screws total, 2 each front and
rear) and bolt to stacked oven base using 3/8 - 16 bolts.
5. Place top oven on lower unit and re-attach with screws for
top of lower oven.
OPERATING INSTRUCTIONS
DO NOT ATTEMPT TO OPERATE THE OVEN until connection
of utility service and installation has been fully inspected (start-up
check-out) by an authorized service technician or a Star Service
Technician in order to assure the oven is properly installed and
in working order. The warranty becomes effective upon
verification of proper installation.
DO NOT WORK AROUND THE CONVEYOR BELT
WITH LONG HAIR, LOOSE CLOTHING, OR DANGLING
JEWELRY. GETTING CAUGHT IN THE BELT COULD
RESULT IN DISMEMBERMENT OR FATAL INJURY.
Unless specified otherwise, conveyor travel is factory set for
left to right operation when facing the front of the oven. If a
direction change is required, refer to "DISPLAY INFORMATION,"
section 3 for instructions on how to program the controller for
a direction change. In addition, the conveyor belt must be
changed to travel in the new direction.
CAUTION

Publicité

loading

Ce manuel est également adapté pour:

Ultramax um1850a