Publicité
Les langues disponibles
Les langues disponibles
CONVEYOR BELT TENSION
The conveyor belt of the Ultra-Max Conveyor Oven
does not have a tension adjustment. If the belt
becomes too loose, a link will have to be removed
to tighten. A belt that is too tight will also cause
operational problems due to excessive drag. We
suggest that you have a qualified service technician
perform this adjustment.
CAUTION
Careful consideration should be exercised prior
to removing a belt link because a belt that is too
tight will impede the smooth operation of the
conveyor.
CONVEYOR BELT LINK REMOVAL
An entire link can be removed with the conveyor
assembly either in or out of the oven. This may be
necessary as the belt stretches after continuous
use. Following are the necessary steps for removing
links:
1. Move the splice clips to either end of the oven for
easy access.
2. Unhook the splice clips using long nose pliers.
3. Unhook the full link to be removed and slide it out.
Do not discard the link removed as it may be used
for making spare splice clips.
4. Reconnect the inside splice clips.
5. Reconnect the outside splice clips.
6. Replace all parts removed from the oven.
7. Straighten any bent wires to ensure smooth
sprocket engagement.
Remove the outside master links on the right
and left sides of the conveyor belt. Remove the
center splice clips next.
Unhook the end loop and pull up on the link
section. Save this link as it may be used for
making splice clips.
Check the orientation of the splice clips (the hooks
should be up). The belt shown is the top section,
ready for left-to-right travel.
13
Publicité
