AquaScape DIY Pond Kit Manuel D'instructions page 22

STEP 12
CONT...
• Remove the waterfall lip from the Biofall, keeping the
screws installed through the waterfall lip and liner.
• Place a thick bead of silicone
across the insert nuts on the
front of the Biofall (See Ex.
26). Pre-installing the two
screws in the earlier steps will
make it easy to line up the
waterfall lip after the silicone
is applied and will keep the
silicone in as thick of a bead
as possible.
• Reattach the waterfall lip
and liner using the two pre-
installed screws. (See Ex. 27)
• Using an awl or nail, poke
the remaining holes in the
waterfall lip and install the rest
of the screws.
(See Ex. 28)
• Remove extra liner, using the
waterfall lip as a guide. Install
the rest of the screws.
(See Ex. 29)
22
Ex. 26
Ex. 27
Ex. 28
www.aquascapeinc.com
• Let dry for at least one hour before introducing water!
Ex. 29
WARNING
Power tools are not recommended for installing the
screws and may strip the nut inserts.
INSTALLING THE FILTER PADS AND MEDIA BAG
• Install the two fi lter pads into the Biofall.
• Add approximately 10 lbs of lava rock or Aquascape
BioBalls™ (not included) into the media net. Set the
media bag on top of the fi lter mats.