AquaScape DIY Pond Kit Manuel D'instructions page 18

STEP 7
CONT...
• With the 4 corners secured,
you may now punch the
remaining holes with your awl
and thread in all the screws.
Again, be careful not to damage
the threads on the nut inserts.
• Let dry for at least one hour
before introducing water.
WARNING
Power tools are not recommended for installing the
screws and may strip the nut inserts
STEP 8
ADD ROCK AND GRAVEL
You can expect to use several tons of stone and gravel for
your water feature. Talk to your Aquascape retailer or rock
yard for help choosing the quantity and sizes of stone and
gravel. Visit www.aquascapeinc.com for information on
calculating the required stone and gravel. Below are some
helpful formulas for choosing the stone and gravel.
Stone Calculation for the Pond
Length x Width / 65 = Tons of boulders
Gravel Used in the Pond
Pond Gravel = 30% total tons of pond boulders
18
Ex. 22
www.aquascapeinc.com
• Start from the bottom and set the largest character
boulders fi rst against the vertical walls, then stack the
smaller boulders on top.
• Be careful when placing any large boulders so you don't
damage the liner.
• The opening on the front of the skimmer can be hidden
by placing boulders on either side and bridging a stone
or piece of driftwood across, creating a cave effect.
Note: Make sure the boulders do not block the water fl ow into
the skimmer.