AquaScape DIY Pond Kit Manuel D'instructions page 21

STEP 11
ADD WATER
• Fill up the pond basin with water. The pond should be
fi lled just below the level of the overfl ow in the
Skimmer.
Note: We recommend adding Aquascape Pond Detoxifi er to dechlorinate and
properly condition water prior to introducing fi sh to your new pond. See your
Aquascape dealer for water treatment products.
STEP 12
HOOK UP THE BIOFALLS
• Prior to installing the waterfall lip, make sure the face of the
fi lter and liner is clean and free of dust and debris.
• Have someone hold the liner against the Biofall while you
line up the waterfall lip over the liner. Make sure there are
®
CAN 1-866-766-3426 |
no wrinkles and the liner comes up above the sides of the
Biofall. Be sure that you have a few inches of slack liner
along the front base of your
Biofall.
This will help reduce tension
on the waterfall lip when
placing boulders in front of
the unit. (See Ex. 23)
• Temporarily install the
waterfall lip and liner to
the Biofall using the two
outermost screws. Using
an awl or nail, poke the fi rst
hole in the liner all the way
through to the inside of the
Biofall. (See Ex. 24 & 25) Be
careful not to damage the
threads on the nut inserts
when punching the holes with
the awl! Remove the awl or
nail while holding waterfall
snout and liner in place and
begin threading one of the
screws into the fi lter.
• Repeat this process for the other screw.
US 1-866-877-6637
Ex. 25
21