Preparations; Prepare The Remote Control; Replace The Remote Control Battery; Install Batteries - SOUNDMASTER UR411 Mode D'emploi

Masquer les pouces Voir aussi pour UR411:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 28

Preparations

Prepare the Remote Control

The provided Remote Control allows the unit to be operated from a distance.
Even if the Remote Control is operated within the effective range (6m), remote control operation may
be impossible if there are any obstacles between the unit and the remote control.
If the Remote Control is operated near other products which generate infrared rays, or if other remote
control devices using infrared rays are used near the unit, it may operate incorrectly. Conversely, the
other products may operate incorrectly.
For First-time use:
The unit has a pre-installed lithium CR2025 battery.Remove the protective tab to
activate the remote control battery.

Replace the Remote Control Battery:

1 Pull out the battery tray and remove the old battery.
2 Avoid touching top/bottom of the battery or it may
impair performance.
3 Place a new CR2025 battery into the battery tray
with correct polarity (+/-) as indicated.
4 Insert the battery tray back into the slot.
Precautions Concerning Batteries
When the Remote Control is not to be used for a long time (more than a month), remove the battery
from the Remote Control to prevent it from leaking.
If the batteries leak, wipe away the leakage inside the battery compartment and replace the batteries
with new ones.
Do not use any batteries other than those specified.
Do not heat or disassemble batteries. Never throw them in fire or water.
Do not carry or store batteries with other metallic objects. Doing so could cause batteries to short
circuit, leak or explode.
Never recharge a battery unless it is confirmed to be a rechargeable type.

Install Batteries

Note:
• You can only use AC power as power supply. Batteries
( not supplied ) are for backup purpose.
• If the system is unplugged or if a power failure occurs, all
setups of the unit will be erased unless there are
batteries in the unit and don't change them at this time.
Once setups had be erased, please resetup all items
(tuner stations; Source...) which you desire.
1 Open the batteries compartment.
2 Install two AAA batteries (not supplied) with correct
polarity and the install steps as indicated.
3 Close the battery compartment.
6

Publicité

Table des Matières
loading

Table des Matières