Optional Front Pellet Loading Kit - Extraflame Nordica Comfort Idro L80 Manuel D'instruction

OPTIONAL FRONT PELLET LOADING KIT

The optional front pellet loading kit allows for the pellets to be loaded into the tank from the front without having to remove
the insert (operation that requires switching off the machine).
Before installing the equipment, it is necessary to make sure that the structure that will cover the insert ensures a hole with the
minimum measurements indicated in the figures below.
The pictures show the minimum measurements between the insert and the cover: these measurements are necessary to allow
for the frame to move correctly and to be removed from its original position.
Assembly is possible even with the insert installed.
cOmFORT IDRO L80
700 X 841 mm wiTh OPTiONAL TRAY
WARNING:
ALWAys FOLLOW ThE INsTRucTIONs IN cOmPLETE sAFETy!
ThE sTOvE musT bE cOmPLETELy cOLD, sWITchED OFF
AND DIscONNEcTED FROm ThE ELEcTRIcAL OuTLET.
FOR ThE cORREcT OPERATION OF ThE INsERT, ThE TRAy musT ALWAys REmAIN
cLOsED EXcEPT FOR WhEN ThE TANK Is bEING LOADED.
WE REcOmmEND NOT LOADING AN AmOuNT OF PELLETs GREATER ThAN ThE cAPAcITy
OF ThE TANK, AND AvOID DROPPING PELLETs INsIDE ThE PRODucT
ENGLISH 17