Publicité
Les langues disponibles
Les langues disponibles
2 |
Description
Modules of all manufacturers can be connected to the controller, the
no-load voltage of the solar modules must be lower than 50 V (see type
plate of the module).
The LEDs at the front of the controller give information on the charging
state of the batteries, status of the consumer connection and whether a
charge current is flowing from the modules or whether the battery is
fully charged.
In the case of the FOX-320 the terminals B1(-), B2(-) and Output are
directly connected with each other via the negative conductor.
Therefore it is important when connecting B1 and B2 that both batteries
are connected to each other at the negative pole with a large wire cross
section.
The Multi Display FOX-MD1 can at any time be connected to the
FOX-320 by simple plug-in. This allows the current voltages and flows
to be displayed, even graphically. The programming function of the
FOX-MD1 enables you to change and save various parameters.
These operating instructions apply to: FOX-320 Version 4.0.
18
Publicité
