Description; Front Panel; Rear Panel - Samsung DSB-9601C Consignes D'utilisation

DESCRIPTION

Front Panel

1 2 3 4
1. This key is used to turn the receiver on and off (Standby).
2. , These keys are used to change the channels.
3. , These keys are used to increase and decrease the volume level
manually.
4. 7 Segment Display This LED display will show the current channel number.
While the receiver is in Standby mode, the display will show the
current time.
5. CAM Slot Slot for Common Interface.
6. Infrared Sensor This is to receive the IR commands from the Remote Control Unit.
N N o o t t e e : CA modules and smart cards are only distributed by service Providers and special
distributors, not by SAMSUNG.
GB-10
5 6
P E R S O N A L V I D E O

Rear Panel

12 11
1. AC MAINS
2. LNB A, B
3. LOOP 1
4. LOOP 2
5. DIGITAL AUDIO OUT Use to connect audio receivers and other equipment with digital inputs.
(SPDIF)
6. RS 232 DATA PORT
7. ANT.IN
8. RF OUT
9. S-VIDEO OUT
10. AV2(SCART)
11. AV1(SCART)
12. VIDEO, AUDIO R/L
R E C O R D E R C O M M O N I N T
DESCRIPTION
4
10 9 8 7 6 5 3 2
This is to plug in the AC mains power cord.
The input AC voltage range is 100V to 240V, 50Hz/60Hz supply.
This port is to connects the satellite antenna cable.
Up to 2 cables can be connected your dish.
The IF input is provided through this port and the input frequency range
is 950-2150 MHz. Also the voltage switching 13V and 18V is passed
through this port.
Use to connect another STB or LNB B.
Use to connect another STB.
This is used to connect your receiver to a computer for reading and
loading data information.
Use to connect your local RF channels to your TV through Loop.
Use to connect your TV via RF cable.
Use to connect components with Super Video capability.
Use to connect your VCR or other equipment.
Use to connect your TV.
Use to connect video and audio from components.
GB-11
E R F A C E
1