RIDGID R82237 Manuel D'utilisation page 6

OPERATION
INSTALLING/REMOVING BITS
See Figure 5, page 8.
 To install bits, lock the switch trigger by placing the
direction of rotation selector in the center position.
 Remove the battery pack.
 Push the bit into the coupler until it clicks into place.
 Pull on the bit to make sure it is secured in the coupler.
There may be some play in the installed bit; this is normal.
NOTE: Use only impact quality bits with a locking groove.
WARNING:
Make sure the bit is secured in the coupler before
using the impact driver. Failure to do so could
cause serious personal injury.
 To remove bits, lock the switch trigger by placing the
direction of rotation selector in the center position.
 Remove the battery pack.
 With the nose of the tool pointed away from you, pull the
coupler away from the driver.
 The bit will eject from the coupler.
USING THE IMPACT DRIVER
See Figures 6 - 7, page 8.
NOTICE:
The impact driver is not designed to be used as
a drill.
WARNING:
Do not drive a screw where there is likely to be
hidden wiring behind the surface. Contact with a
"live" wire will make exposed metal parts of the tool
"live" and possibly shock the operator. If you must
drive a screw where hidden wire may be present,
always hold tool by insulated gripping surfaces
(handle) when performing the operation to prevent
a shock to the operator.
NOTE: Maintenance information begins on page 7
after French and Spanish language sections. Figures
This product has a 90-Day Satisfaction Guarantee Policy,
as well as a Three-year Limited Warranty. For Warranty
and Policy details, please go to www.RIDGID.com
(Illustrations) start on page 8.
or call (toll free) 1-866-539-1710.
6 - English
 Check the direction of rotation selector for the correct
setting (forward or reverse).
 Hold the impact driver with one hand.
 Place the bit on the screw head, bolt head, or nut and
slowly depress the switch trigger. Start the bit slowly for
more control.
 As the screw, bolt, or nut is driven, impacting will begin.
ELECTRIC BRAKE
The electric brake will stop the bit rotation after the operator
releases the switch trigger.
ON-BOARD FUEL GAUGE
The on-board fuel gauge lights up to indicate the amount of
charge in the battery pack when the operator pulls the trigger.
LED INDICATOR
LED begins flashing when the bat-
tery pack needs to be recharged.
% CHARGED
0%-25%
26%-50%
51%-75%
76%-100%