Weight Unit Selection; Reset To Zero; Overload Message; Piece Counting Function - BLAUSCAL AH Serie Manuel D'utilisation

WEIGHT UNIT SELECTION

Press the UNITS key to select the weight units, the display will view the options.
There are 8 weight units available.

RESET TO ZERO

If the zero value varies during the weighing, press the key, the display will
show zero again.
TARE
This function allows calculating the net weight of a product.
With display showing "zero", place a container on the pan, then press the key,
the balance will subtract the container´s weight, put the product into the container
and then read the product´s weight on the display (net weight)
To return to normal weighing model, remove the container and press the
key.

OVERLOAD MESSAGE

If an object is placed on the pan and its weight exceeds the maximal capacity of
the balance, the display will show the message "-----OL-----", at the same time, the
balance will beep. Remove the object; otherwise it may damage the mechanism of
the balance.
PIECES COUNTING FUNCTION
The pieces counting function is used to count the number of pieces deposited on
the pan.
Place a container on the pan and press the key.
Insert a certain number of pieces (10, 20, 50 or 100) into the container. This
number of pieces is the initial sample, the higher number grants more accuracy in
final counting.
Press the MODE key, select the desired sample number using the or UNITS
keys. To confirm the selected value, press the PCS key.
The balance will accept the sample and after a few minutes will indicate the pieces
counting mode.
The display will show the number of pieces placed on the pan, add the rest of
7