Installation; Description Of Display - BLAUSCAL AH Serie Manuel D'utilisation

INSTALLATION

1. Remove the package from the carton.
2. Remove the pan from the cardboard.
3. Remove the AC/Adaptor (it is inside a white box).
3. Take out the balance from its protection and place it on its definitive place of
use, which should be a flat, non-metallic, most stable and rigid surface.
4. Put the stainless steel pan on the pan support.
5. Level the balance by turning the four adjustable feet until the bubble level
located on left frontal side remains in the centre of the circle.
6. Connect the AC/Adaptor to the balance´s connector and then to an outlet of
220/240 V. 50 Hz..
7. Calibrate the balance with a proper calibration weight. This action is very
important in order to obtain accurate weighing results.
8. For maximum accuracy, it is necessary to keep the balance connected for about
60 minutes before using it. However, the balance can also be used immediately
with good results.

DESCRIPTION OF DISPLAY

Zero It lights when the display is at zero.
Tare It lights when a container or product have been tared.
Stable It appears when balance is stable.
Modo It lights when the "mode" key is pressed.
Setup It lights when the "Setup" key is pressed.
Cal It appears when the balance is in calibration mode.
Battery indicator
Use to change
Press enter The display shows it when it is needed to confirm the function.
Press Esc The display shows it when you can return to previous menu or exit.
Weight units symbols: ct: Quilate lb: pound oz: ounce GN: grain
ozt: troy ounce
dwt: pennyweight
Used to navigate through the menu.
5