Care And Maintenance; Environmental Protection; Manufacturer's Warranty - Tools - Hilti DD-VPX Mode D'emploi

Care and maintenance

Before the pump is switched off and if it will not be
used for a long period, it should always be allowed to
run for 5 minutes under no load.
Clean the outside of the tool at regular inter-
vals using a slightly damp cloth. Don't use a spray, steam
pressure cleaning equipment or running water for clea-
ning. This may negatively affect the electrical safety of
the tool. Always keep the grip surfaces of the tool free
from oil and grease. Don't use cleaning agents which
contain silicone.
Never operate the tool when the ventilation slots
are blocked. Clean the ventilation slots carefully using
a dry cloth. Don't permit foreign objects to enter the inte-
rior of the tool.

Environmental protection

Return waste material for recycling
The machine and packaging must be sorted for envi-
ronment-friendly recycling.
The plastic components are marked to facilitate cate-
gorised recycling.
Only for EU countries
Disposal of electric tools together with
household waste is not permissible!
In observance of European Directive
2002/96/EC on waste electrical and
electronic equipment and its
implementation in accordance with
national law, electric tools that have
reached the end of their life must be
collected separately and returned to an
environmentally compatible recycling
facility.
Printed: 07.07.2013 | Doc-Nr: PUB / 5069649 / 000 / 00
Manufacturer's warranty – tools
Hilti warrants that the tool supplied is free of defects
in material and workmanship. This warranty is valid so
long as the tool is operated and handled correctly,
cleaned and serviced properly and in accordance with
the Hilti Operating Instructions, and the technical sys-
tem is maintained. This means that only original Hilti
consumables, components and spare parts may be
used in the tool.
This warranty provides the free-of-charge repair or
replacement of defective parts only over the entire lifes-
pan of the tool. Parts requiring repair or replacement
as a result of normal wear and tear are not covered by
this warranty.
Additional claims are excluded, unless stringent
national rules prohibit such exclusion. In particular,
Hilti is not obligated for direct, indirect, incidental
or consequential damages, losses or expenses in
connection with, or by reason of, the use of, or inabil-
ity to use the tool for any purpose. Implied warranties
of merchantability or fitness for a particular purpose
are specifically excluded.
For repair or replacement, send tool or related parts
immediately upon discovery of the defect to the address
of the local Hilti marketing organization provided.
This constitutes Hilti's entire obligation with regard to
warranty and supersedes all prior or contemporane-
ous comments and oral or written agreements con-
cerning warranties.
11