Publicité
Fax +32 2 359 95 50
Never vacuum toxic materials, as vapors and dust can be
hazardous to your health.
Never use the appliance to vacuum mortar, cement or other
substances that harden on contact with water and may interfere
with normal operation of the vacuum cleaner.
Do not use the appliance on pets.
Sparks within the motor can ignite flammable vapors or dust.
Never use it near flammable or explosive liquids (such as
gasoline, oil paints, detergents), near gases, explosive
substances (such as coal dust, magnesium, gunpowder), smoke
or fire sources.
Use only accessories recommended by the supplier. Other
accessories pose a danger to the user and could damage the
appliance.
Always unplug the AC adapter from the wall outlet by pulling on
the plug itself. Never pull on the charging cable.
Regularly remove blockages caused by hair, dust fluff and the
like in order not to reduce the suction power.
ASSEMBLING THE VACUUM CLEANER
Unpack the device and all accessories.
Make sure that all parts mentioned in the manual are present and undamaged.
Carefully secure the handle (8) to the main unit. To do this, carefully pull on the supplied
locking screw (9) (Ill. 4, Fig. 1).
Insert the hand vacuum cleaner (4) into the main unit. For this, the device must always be
switched off. Pay attention to the "click" sound when snapping in (Ill. 4, Fig. 3). Make sure
that there are no substances between the contacts of the handpiece (4) and the main
unit,
Charge the battery in the following situations:
Before first use; in this case, the battery must be fully charged (6-8 hours).
-
After a long period without use. (For optimal battery life, we recommend
-
charging the device at least every three months.)
To load, the hand vacuum cleaner (4) must be inserted in the main unit (Ill. 5, Fig. 4).
Plug the mains adapter of the charging cable (14) into a socket (Ill. 5, Fig. 5). Connect the
charging cable (14) to the charging port (10) of the main unit (Ill. 5,Fig. 6). Make sure that
the contacts on the charging cable and the vacuum cleaner are clean. If necessary,
remove the charging cable and clean the connectors.
The charge indicator (4) turns red while the battery is charging (Ill. 5, Fig. 7) and turns to
blue when the battery is fully charged.
Both the charging cable and the vacuum cleaner may become warm while charging.
This is completely normal.
Copies of the I/B. Please reproduce them without any changes
except under special instruction from Team International BELGIUM.
The pages must be reproduced and folded in order to obtain a
booklet A5 (+/- 148.5 mm width x 210 mm height). When folding,
make sure you keep the good numbering when you turn the pages
of the I/B. Don't change the page numbering. Keep the language
integrity.
9
Assembly page 9/28
TKG SKV 1004 - 180329
Publicité
