Publicité
Les langues disponibles
Les langues disponibles
Operation (Continued)
3. After using detergents, flush the suction system by placing
the detergent suction tube into a bucket of clean water
and spraying with the black spray nozzle.
CLEANING POWER
The easiest way to regulate the cleaning power of your
pressure washer is by changing the distance from the
surface you are cleaning. Begin spraying with a wide fan
pattern while standing several feet from the surface. Slowly
move closer to the object you are cleaning, adjusting the
spray pattern as necessary, until you find the most effective
cleaning technique.
FINAL RINSE
The final rinse should start at the top and work downward.
Make sure that you thoroughly rinse the surface and that you
remove all detergent.
PRESSURE RELIEF PROCEDURE
To reduce the risk of bodily injury or property damage,
always follow this procedure whenever spraying is stopped,
when work is completed, and before checking or repairing
any part of the system.
1. Engage the trigger safety latch.
2. Turn the unit off.
3. Shut off the water supply.
4. Disengage the trigger safety latch and trigger the gun to
relieve pressure.
5. Re-engage the trigger safety latch.
6. When checking or repairing unit, remove the wall outlet
plug from the wall.
7. Before overnight storage, long term storage, or
transporting unit, disconnect the water supply.
SHUTDOWN
1. Be sure all detergent is flushed from system.
2. Turn the motor OFF.
3 Turn the water supply OFF.
4. After the motor and water supply are turned off, trigger
the gun to depressurize the system.
NEVER turn the water supply off before
turning the engine/motor off. Serious
damage could occur to the pump and/or engine/motor.
NEVER disconnect the high pressure
discharge hose from the machine while
the system is pressurized. To depressurize, turn engine/motor
off, turn water supply off and squeeze gun trigger 2-3 times.
5. After each use, wipe all surfaces of the pressure washer
with a clean, damp cloth.
STORAGE
•
Do not store the pressure washer outdoors.
•
Do not store the pressure washer where it might freeze
unless it has been properly winterized.
Long Term Storage Instructions (more than 30 Days in
storage)
1. Remove fuel from the tank and run the pressure washer
in a normal operating mode until the engine stops from
a lack of fuel. Normal operating mode means actually
spraying water from the gun while the engine is running.
Alternate method – Add fuel stabilizer to gas in the
tank and run in normal operating mode for at least five
minutes.
2. Stop the engine, turn off the water supply, and trigger
the gun to release pressure in the high-pressure hose.
3. Disconnect the water supply and high pressure hose from
the pump.
4. Allow the engine to cool.
5. Disconnect the spark plug wire and remove the spark
plug.
6. Pour 1/2 oz. of engine oil into the spark plug hole.
plug hole is covered. Fuel vapor from the hole can ignite by a spark.
7. Place a rag over the spark plug hole and slowly pull the
starter rope several times to distribute the oil.
WINTERIZING INSTRUCTIONS
1. Follow and complete the Long Term Storage Instructions.
2. Disconnect the spark plug wire.
3. Disconnect the high pressure hose from the pump.
4. Insert a 12 in. to 14 in. piece of garden hose into the
pump inlet.
5. Place a funnel in the other end of the garden hose.
6. Pour approximately 6 oz. of RV antifreeze into the funnel.
7. Pull the starter rope several times until the RV antifreeze
comes out of the pump outlet.
8. Disconnect the high pressure hose from the gun and drain
the hose. Hold the gun and lance in a vertical position
and squeeze the trigger to drain the water out.
TIPS FOR EXTENDING THE LIFE OF YOUR PRESSURE
WASHER
1. Never operate the unit without water.
2. Your pressure washer is not meant to pump hot water.
Never connect your pressure washer to a hot water supply
as it will significantly reduce the life of the pump.
3. Running the unit for more than one minute without
spraying water causes heat to build up in the pump.
Running the unit without spraying water can damage
pump components.
Maintenance
Observe regular maintenance intervals to ensure maximum
performance and life from the pressure washer. Refer to the
schedule for recommended maintenance. If you operate the
pressure washer in dusty conditions, perform maintenance
checks more often.
www.campbellhausfeld.com
MODEL: PW2570
Never pull the starter rope on the engine when
the spark plug is removed unless the spark
Read the manufacturer's instructions for safe
handling and disposal of RV antifreeze.
9
Publicité
