Packaging Components - GRE AR119 Manuel D'installation Et D'entretien

INSTRUCTIONS FOR MONOBLOC FILTER
Read this manual thoroughly before installing the filter and carefully follow the instructions during installation and use.
Keep this manual for future reference regarding the operation of this apparatus.
• All electrical installations should comply with the following standard;
that refers "to the construction of electrical installations, both in indoor and outdoor swimming pools", or the equivalent
standard in force in each region or country.
• All filtering should follow the C 15-100 installation standard that stipulates that all electrical apparatus located at less
than 3.5 m. from the pool and freely accessible, should be supplied by a very low voltage of 12 V. All apparatus
supplied with 220 V should be located at least 3.5 m. from the swimming pool edge. Ask the manufacturer for
permission to make any modifications in one or more elements of the filtering system.
• The electrical installation should be performed by professional staff qualified in electrical installations.
• The height of the sand should not exceed 2/3 of the height of the tank.
• The apparatus must not be on while the pool is being used.
• Do not operate the apparatus unless it is properly primed.
• NEVER touch the filter when it is operating if you are wet or have wet hands.
• When handling the filter or valve, DISCONNECT the power supply.
• Make sure that the ground is dry before touching the electrical equipment.
• Do not install the filter where it could become wet, as it may cause electrocution.
• Do not allow children or adults to lean against or sit on the apparatus.
• If the supply flex of the apparatus is damaged, it should be replaced. Read the instructions carefully to replace it.
If in doubt, contact the technical service.
1

PACKAGING COMPONENTS

The monobloc which you have just purchased is a device which is especially planned and designed to be used in
elevated pools. As a result of its innovative design and excellent functionality, it provides you with the different
components required to filter water: a single unit which includes filter and pump.
The main components of this monobloc are as follows:
Pos. Fig.
1 6
2 6
3 6
4 6
5 6
6 6
7 6
8 7
9 4-5
10 4-5
Check that your monobloc unit includes all of the components.
1.1 REQUIREMENTS FOR CORRECT INSTALLATION
This apparatus is easy to install and can be assembled by one adult in about 2 HOURS, taking care to correctly follow
the instructions detailed in this manual.
Only the following tools are required to correctly handle the filter components and to install it.
Task
Tighten the hose flanges
Cut the liner
Protection of collector pipe
SAFETY INSTRUCTIONS. READ CAREFULLY
NF EN 60-335-2-41
Amt. Name
1 Hose ø25 mm, 4.5 m length (feedback).
1 Feedback valve, coupling and nut with ø25 mm connection
1 Hose ø32 mm, 4.5 m. length (suction).
1 Suction valve, coupling and nut with ø32 mm connection
1 Hose ø25 mm, 1 m. length (discharge).
1 Filter unit (pump, carboy, 10 kg. dry load, cable, upper connection and nut).
6 Hose securing clamps.
1 Hose adapter (Sand backwash)
4 Drag rings.
4 Sealing gaskets.
Tool
7mm Stecker screwdriver
Cutter
Piece of plastic
NF C15-100
2
ENGLISH
Alternative tool
Philips screwdriver
Knife
Piece of fabric