Rj45 - IDEAL 33-772 Mode D'emploi

Screen #L-2 General Description
1. M12, M12>RJ-45, RJ-45, COAX(R-J45)
shows on the first and second line; Use
Up and Down keys to select, (M12 is
default setting);
2. ID number is displayed only when a
Remote is being used;
3. To change pair measure of other types of
cables, press SELECT to cycle through.
Screen #L-3
1. M12 cable (default) is selected
2. A brief message 'select a pair #' appears
on the screen for just 2 seconds
3. Use SEL key to scroll through pairs
(1-2, 3-4, auto), and auto (in this case
3-4 pair is selected)
4. If no fault is detected, cable length and
pair number will be displayed.
5. If there is a short, error message will
replace length reading.
Screen #L-4
1. Use Up and Down keys to select
M12>RJ-45 as cable type to measure
length;
2. ID number is displayed only when a
Remote is being used
3. To change pair measure, press SELECT
to cycle through 1-2, 3-6 or auto
Screen #L-5
1. RJ45 is selected;
2. A brief message 'select a pair #' appears
on the screen,
3. Use SELECT key to scroll through and
select a pair from1-2, 3-6, 4-5, 7-8 or auto;
4. If no fault is detected, cable length and pair
number will be displayed;
5. If there is a short, error message will
replace length reading (see next screen #6)
M12

RJ45

Select type to
measure length
MODE=ESC, SEL=go
Displays on third line "Select type to
measure length" repeat cycling
M12
Select type to
measure length
MODE=ESC, SEL=go
RJ45
11
M12>RJ45
COAX(RJ45)
LENGTH
6.0ft
15.000pF/ft
M12>RJ45
LENGTH
6.0ft
15.000pF/ft
3-4
3-6