IDEAL 33-772 Mode D'emploi page 15

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TONE on coax (video) cable
1. On the first line, COAX(RJ-45) is shown,
a coax cable is ready to accept a tone;
2. On the second line Selected pins are
shown;
3. On the third line, selected tone is
displayed.
4. Up & Down keys and Pair or Pin are also
displayed on the last line. When sending
tone in the COAX (RJ45) mode, use the
RJ45 port on the IE Net PRO with the
included RJ45 to BNC adapter.
HUB Blink
HUB Blink mode selected
IENet™ PRO cable tester works on a HUB or a Switch
1. Connect Tester to a HUB or Switch by
means of a jumper cable;
2. Press MODE to select HUB BLINK and
press SELECT to enter,
3. The Tester sends a link pulse to the NIC
for 3 seconds and stops sending for
another 3 seconds interval, making a cycle time of 6 seconds in total.
4. When sending pulse, the tester displays 'Test' and goes off when not sending.
5. When the HUB is receiving the pulse, the indicator light of responsive port
blinks.
Setup Mode
When in Setup mode
Three selectable options:
• To select between Shielded and
Unshielded,
• To select between Pass Beep-On and
Pass Beep-Off (Note: Beeper sounds when
test result is normal or when a cable carries voltage),
• To change units of length, Units-feet or Units-meters.
COAX(RJ45)
PS
SEL Hi Tone
Press Up and Down arrow keys to configure
PS, P, S to apply tones.
Press SEL key to choose any of the four
tone sounds: Tone 1, Tone 2, Hi Tone, Lo
Tone (choose Hi on pair and Low on pin).
M O D E = n e x t , S E L = g o
Test
HUB BLINK
M O D E = n e x t , S E L = g o
15
TONE
Pair
or
HUB BLINK
SETUP
Pin

Publicité

Table des Matières
loading

Table des Matières