Radio Operations; Listening To The Radio - JVC KD-AR800 Manuel D'instructions

RADIO OPERATIONS

Listening to the radio

You can use either automatic searching or manual
searching to tune in to a particular station.
Searching for a station automatically:
Auto search
1
Select the band (FM1 – 3, AM).
FM 1
(F1)
Lights up when receiving an FM stereo
broadcast with sufficient signal strength.
* When "CLOCK DISP" is set to "CLK DISP
ON" (see page 28), the current indication will
soon change to the clock time.
Note:
This receiver has three FM bands (FM1, FM2,
FM3). You can use any one of them to listen to
an FM broadcast.
10
Each time you press the
button, the band changes as
follows:
FM 2 FM 3 A M
(F2) (F3) (A1)
Selected band appears*.
2
Start searching for a station.
To search for stations of lower frequencies
When a station is received, searching stops.
To stop searching before a station is received,
press the same button you have pressed for
searching.
Searching for a station manually:
Manual search
1
Select the band (FM1 – 3, AM).
Each time you press the
button, the band changes as
follows:
FM 1 FM 2
(F1) (F2)
Note:
This receiver has three FM bands (FM1, FM2,
FM3). You can use any one of them to listen to an
FM broadcast.
2
Press and hold
"M.SEEK" (manual seek) appears on
the display.
To search for stations of
higher frequencies
FM 3 A M
(F3) (A1)
¢ or 4
until