Publicité
Step 4
å
Separate the WIDE EXTENSION SLIDES (32) from the WIDE EXTENSION RAILS (31) as shown in the upper diagram
below. Be prepared, the parts are greasy.
å
Fasten the WIDE EXTENSION RAILS (31) to the ENDS (B and C). Use sixteen BLACK 5/8" FLAT HEAD SCREWS (21).
å
NOTE: For each WIDE EXTENSION RAIL, turn a SCREW into the 1
cartridge of the EXTENSION RAIL in to find the other holes that line up with the holes in the END. Turn a SCREW into
these holes.
å
NOTE: The WIDE EXTENSION SLIDES will be used later for the DRAWERS.
å
Fasten the INTERLOCK MECHANISMS (15) to the ENDS (B and C). Use six BLACK 5/8" FLAT HEAD SCREWS (21).
Push the black lever up and
pull the SLIDE from the RAIL.
15
Page 8
32
31
31
B
www.sauder.com/service
hole shown in the diagram. Then, slide the inner
st
31
Use these holes.
BLACK 5/8" FLAT HEAD SCREW
(22 used in this step)
Closed end
31
C
31
7
1
hole
st
Closed end
21
15
428241
Publicité
