Publicité
Les langues disponibles
Les langues disponibles
Power/Out
Power
of Water
Indicator
POWER ON/OFF BUTTON & OUT OF WATER INDICATOR
Plug unit into a 120-volt AC electrical outlet. Press the power
When the humidifier is out of water, the LED will glow red.
NOTE: If the mist chimney is not completely locked, the water reservoir will overfill causing the out of
water LED to glow red. Should this happen, follow steps 1-3 in the cleaning the transducer/ultrasonic
membrane instructions.
MIST OUTPUT
Mist adjusts from the lowest output (1) to the highest output (2). To increase the mist output, press the
mist output
button. The corresponding mist level will be lit above the
mist output
button to cycle through the mist output settings.
MIST TEMPERATURE SETTING
To change the mist temperature from cool to warm mist, press the mist temperature
be illuminated above the button. To change the mist temperature from warm to cool mist, press the mist
temperature
button again. The LED will turn off.
NOTE: Once warm mist is selected, it will take approximately 20 minutes to heat up before the mist
becomes warm.
360° DUAL ROTATING MIST NOZZLE
Rotate the tank cap to adjust the mist output direction. Rotate the smaller tank cap ring to direct the mist
output to a second direction.
NIGHTLIGHT
The nightlight feature has 3 brightness levels: low, medium, and high. Continuously press the nightlight
button to cycle through low, medium, high, and off.
The nightlight feature can be used when the humidifier is off.
Mist
Mist
Output
Temperature
7
Nightlight
Timer
button to turn unit on.
button. Continue to press the
Clean
Transducer/
Ultrasonic
Membrane
Indicator
button. Red will
Publicité
