DeWalt DCL510 Traduction De La Notice D'instructions Originale page 57

Using an Extension Cable
An extension cord should not be used unless absolutely necessary.
Use an approved extension cable suitable for the power input of your
charger (see technical data). The minimum conductor size is 1 mm
the maximum length is 30 m.
When using a cable reel, always unwind the cable completely.
ASSEMBLY AND ADJUSTMENTS
WARNING: Use only D
chargers.
Inserting and Removing the Battery Pack
from the Tool (fi g. 2)
NOTE: Make sure your battery pack (f) is fully charged.
TO INSTALL THE BATTERY PACK INTO THE TOOL HANDLE
1. Align the battery pack with the rails inside the handle.
2. Slide it firmly into place until you hear the lock snap into place.
TO REMOVE THE BATTERY PACK FROM THE TOOL
1. Press the release button (g) and firmly pull the battery pack out of
the tool handle.
2. Insert battery pack into the charger as described in the charger
section of this manual.
OPERATION
Instructions for Use
WARNING: Always observe the safety instructions and
applicable regulations.
Switch (fi g. 1)
To turn the light on, press the switch (a). To turn it off, press the switch
again.
E NGLI SH
WALT battery packs and
E
;
2
55