Lorex LNZ3522B Manuel D'utilisation page 12

5
Connecting the Camera
ports to provide power and Pan-Tilt commands to the camera, as well as vid-
eo connection to the NVR. In order to use PoE with this IP camera, you must
connect it directly to a compatible NVR (Lorex LNR100 & LNR400 Series on-
ly) or a PoE switch on the same network as the NVR.
PoE switches are available for purchase on www.lorextechnology.com.
Complete the following steps to connect the camera to the NVR over the LAN.
Step 1 of 2 — OPTION A: Connecting the camera to your local network
using an optional PoE switch:
1. Connect an Ethernet cable of up to 300ft (91m) rated CAT5e or higher
(not included) from the LAN port on an external PoE switch (sold sepa-
rately on
ble to the PoE switch and to a power outlet or surge protector.
Terminology may vary depending on the model of PoE switch you have.
2. Connect the camera to the PoE switch using the included Ethernet cable
(or a CAT5e Ethernet cable of up to 300ft (91m)). The PoE switch will pro-
vide power and video transmission the same way as your NVR.
#LX400043; r. 1.0/19290/23171; en-US
www.lorextechnology.com) to your router. Connect the power ca-
NOTE
6