TurMix A33140 Mode D'emploi page 64

Instructions for use
Insert the knife appliance
Insert the knife appliance into the glass from below and turn it
until the positioning aids slot into place. Press the knife appliance
2
against the glass and turn the bottom ring clockwise until you hear
it click. The knife appliance can be removed by following these
1
steps in a reversed order.
Attach the mixing glass
The blender has been fitted with a safety mechanism that is activated
when the glass is in contact with the base. Thus, when placing the
glass on the base ensure that a quiet clicking sound of the micro sen­
sors can be heard (the locking device is then unlocked). The glass
can be placed on the base in 4 positions (respectively at a 90° angle
from each other). Fill the blender with ingredients and put the lid on
top. Make sure that the shape of the lid fits on the shape of the glass.
Turn the device on / off, add more ingredients
Plug the power plug in. Adjust the switch to the desired setting or
hold it on the «pulse» setting. Ingredients can be filled via the open­
ing in the lid or turn the device off and remove the lid. If an air
bubble should shape around the knife, turn off the device, lift the
mixing glass from the base and stir the contents to allow the air to
disappear. After use, turn the device off and unplug it.