The First Wash Cycle; Technical Details - Indesit WITL 6 Mode D'emploi

Connecting the drain hose
!
We advise against the use of hose extensions; in case
of absolute need, the extension must have the same
diameter as the original hose and must not exceed 150
cm in length.
Electric connection
Before plugging the appliance into the mains socket,
make sure that:
• the socket is earthed and in compliance with the
applicable law;
• the socket is able to sustain the appliance's
maximum power load indicated in the Technical
details table (on the right);
• the supply voltage is included within the values i
ndicated on the Technical details table
(on the right);
• the socket is compatible with the washing
machine's plug. If this is not the case, replace
the socket or the plug.
!
The washing machine should not be installed in an ou-
tdoor environment, not even when the area is sheltered,
because it may be very dangerous to leave it exposed to
rain and thunderstorms.
!
When the washing machine is installed, the mains so-
cket must be within easy reach.
Connect the drain hose,
without bending it, to a
draining duct or a wall
drain situated between 65
and 100 cm from the floor;
alternatively, place it over
the edge of a basin, sink
or tub, fastening the duct
supplied to the tap (see
figure). The free end of
the hose should not be
underwater.
!
Do not use extensions or multiple sockets.
!
The power supply cable must never be bent or dange-
rously compressed.
!
The power supply cable must only be replaced by an
authorised serviceman.
Warning! The company denies all liability if and when
these norms are not respected.

The first wash cycle

Once the appliance has been installed, and before you
use it for the first time, run a wash cycle with detergent
and no laundry, setting the 90°C programme without a
pre-wash cycle.

Technical details

Model
WITL 6
40 cm wide
Dimensions 85 cm high
60 cm deep
Capacity from 1 to 5 kg
Electric
Please refer to the technical data plate
fixed to the machine.
connections
maximum pressure 1 MPa (10 bar)
Water
minimum pressure 0.05 MPa (0.5 bar)
connections
drum capacity 42 litres
Spin speed up to 600 rpm
Control
programmes
programme 3; temperature 60°C;
according to
run with a load of 5 kg.
EN 60456
directive
This appliance is compliant with
the following European Community
Directives:
- 89/336/CEE of 03/05/89 (Electro-
magnetic Compatibility) and subse-
quent amendments
- 2006/95/CE (Low Voltage)
- 2002/96/CE
GB
3